LuxaFlex PowerView Motorisation Guide

Pairing additional remote(s) to the
PowerView Shade Network
Follow these steps to copy the PowerView Shade Network
I.D. from the original remote to additional remotes. All
remotes in a home should be added to the same PowerView
Shade Network. This allows for easy installation of additional
control options, such as the PowerView Hub and PowerView
Repeaters. Remotes paired to the same network will be able
to operate the specific window coverings they are assigned
to.
1. Remove the back cover from the new remote.
2. Press and hold the recessed Reset button for 6
seconds, until the GROUP buttons flash twice. The
backlit buttons on the remote will flash to indicate the
remote is in learning mode. Reinstall the back cover.
3. Press and hold STOP for 4 seconds on the original
remote to put the remote in program mode. The
backlit buttons on the remote will flash to indicate
it is in program mode.
4. Press and hold the STOP button on the new
remote while pressing and releasing STOP on
the original remote.
5. The backlit GROUP buttons on the new remote will
flash twice to indicate the Shade Network I.D. has
been copied.
6. Press and hold STOP for 4 seconds on the original
remote to exit program mode. The lights will stop
flashing.
15
PROGRAMMING

LuxaFlex PowerView Motorisation Specifications

General

Brand	LuxaFlex
Model	PowerView Motorisation
Category	Remote Control
Language	English