Need help?Do you have a question about the LuxaFlex PowerView Pebble Remote and is the answer not in the manual?
General| Model | PowerView Pebble Remote |
|---|---|
| Category | Controller |
| Battery Type | CR2032 |
| Connectivity | Radio Frequency |
| Battery Life | Up to 2 years |
| Weight | 1.6 ounces |
Identifies essential items required for single or multiple shade setup with PowerView AC motors.
Details the front and back components of the PowerView remote modules.
Describes the PowerView Pebble and PowerView Surface remote models.
Guides on activating the remote and mounting the PowerView Surface.
Establishes a unified PowerView Shade Network ID for multiple remotes.
Procedure for adding a roller shade to a specific group via the remote.
Instructions to reverse the motor's direction if it operates incorrectly.
Process for defining the highest position the shade can travel.
Process for defining the lowest position the shade can travel.
Instructions for saving a custom preferred shade position.
Guide on copying settings from an existing remote to a new one.
Verifies correct operation of motors, limits, and the shade network.
Procedures to reset the upper and lower travel limits of the motor.
Steps to disassociate a shade from its assigned group.
How to disable the remote's backlights to conserve battery.
Erases all group assignments and network settings from the shade.
Restores the motor to its original factory settings, clearing all programming.
Instructions for operating the M40 motor using dry contact inputs.
To Next Page