To Next Page

To Previous Page

USING MULTIPLE REMOTES WITHIN A HOME (PAIRING REMOTES TO A SINGLENETWORK ID)

To program your PowerView AC motor and roller shade, you will need to perform the following 9 steps:

STEP 1: Join a Shade to a Group

STEP 2: Reverse the Motor Direction (If Necessary)

STEP 3: Set the Motor Upper Limit

STEP 4: Set the Motor Lower Limit

STEP 5: Set a Favourite Position (Optional)

STEP 6: Creating a Duplicate Remote

STEP 7: Test the Motors and PowerView Shade Network

STEP 1 — JOIN A SHADE TO A GROUP

1. Remote: press and hold STOP for 6 seconds to put the remote into program mode.

The backlit buttons on the remote will flash to

indicate it is in program mode.

2. Remote: press and release the desired GROUP

number (1 – 6).

The backlit GROUP number will flash to show it is

selected.

3. Motor: press and hold the manual control button

located on the motor head.

4. Remote: while continuing to press the manual control button,

press and release OPEN on the remote.

The shade will move twice to indicate it has joined the group.

5. Motor: release the manual control button.

6. Remote: press and hold STOP for 6 seconds to exit

program mode. The lights will stop flashing.

WARNING: The AC motor will not operate correctly until limits are set (Step 3 and Step 4).

PROGRAMMING OVERVIEW

LuxaFlex PowerView Pebble Remote User Manual

Questions and Answers: