Luxier SS-B01-TB User Manual

1
SS-B01Rev. D 012019Luxier
SS-B01-TB (Brushed Nickel)
SS-B01-TC (Chrome)
SS-B01-TM (Matte Black)
SS-B01-TO (Oil Rubbed Bronze)
Rainfall Shower System
Pressure Balance Valve and Shower Trim Installation
IMPORTANT!
• Read and understand this instructions completely before installation. Failure to follow these
instructions could prevent the valve from working properly. Consult a professional installer if needed.
• This installation guide is subject to change without notice, please contact us to request the most
updated version of this installation guide.
• This is a general installation guideline, actual installation may vary. It is recommended the
installation is performed by a trained and experienced installer.
• Please follow all local building and plumbing codes.
• Product drawings in this installation guide is for illustration purpose only. Actual product may vary
depends on model.
• Always take extra precautions and wear appropriate safety equipment when installing this product.
• Unpack and inspect the shower panel from the package for shipping damage and make sure all parts
are included with the shower panel.
• Keep the product in its package until you are ready to install.
• Make sure the installation site is clean and free of dust and debris.
• Please make sure the water supply is shut o to the installation area. If necessary, shut o the
water to the entire house.
• Turn on the water at a bathroom faucet in the house to relieve the pressure in the plumbing system.
Tools and Materials Needed:
1. Safety Glasses
2. Teon (PTFE) Tape
3. Plumber’s Putty and Caulking
4. Tube Cutter
5. Adjustable Wrench
6. Screwdriver Sets
7. Tourch
8. Hacksaw
9. Marker
Specications:
Shower head ow rate: maximum 1.8 gpm at 80 psi
Plumbing connection: standard 1/2” pipe tting

Luxier SS-B01-TB Specifications

General

Brand	Luxier
Model	SS-B01-TB
Category	Bathroom Fixtures
Language	English

Summary

Rainfall Shower System

Pressure Balance Valve and Shower Trim Installation

Details on installing the pressure balance valve and shower trim.

Specifications

Technical specifications including flow rate and plumbing connection type.

Tools and Materials Needed

List of tools and materials required for installation.

Limited Lifetime Warranty

Maintenance Guide

Parts Diagram & Dimensions

Installation

Position Valve Body in Wall

Guidance on positioning the valve body within the wall, including depth.

Connect Valve to Plumbing

Instructions for connecting the valve to the plumbing system.

Install Components After Soldering

Steps for installing stop valves, cartridge, and nipple after soldering.

Pressure Test and Flush Valve

Procedure for pressure testing and flushing the installed valve.

Installation (Cont.)

Attach Handle and Escutcheon Plate

Attaching the handle and escutcheon plate to the valve assembly.

Trim Nipple and Stem

Trimming the threaded nipple and valve stem for proper fit.

Re-install Components and Attach Handle

Re-installing components and final handle attachment.

Attach Shower Arm and Head

Connecting the shower arm and shower head to the assembly.