Luxman D-105U Service Manual

D-105U
<Cabinet of Section
1. Removal of Top Cover
(1) Remove ten screws marked ‘‘@’’ as shown
Figure 4.
(2) Pull out the top cover in the direction of the
arrow as shown in Figure 4.
1. EBOWLA
(1) lUKDAY“*O’LXALET, (4HER)
2) ERX EMOAMIIISETTHULET. (4BER)
2. Removal of the Front Panel
(1) After removing the Top Cover, open the
Disk Tray and pull the Tray Panel in the
direction as shown in Figure 5.
Remove the Power switch knob as shown in
Figure 5.
(3) Remove the solder (A) as shown in Figure 6.
Note: Be careful not to damage the paral-
lel wires (29P) when removing the
solder (A).
(4) Remove the three screws marked “©"’ as
shown in Figure 7.
Remove the hook (A) located in the two
places as shown in Figure 6.
(6) Disconnect all wires connected to the follow-
ing P.C. Boards: FL/Keyboard P.C. Board,
Tube P.C.Board (1)/(2), Remote P.C.
Board, Pre-Heat SW. P.C. Board, Head-
Phone Jack P.C. Board.
The Front Panel can now be removed with
the following P.C. Boards in place: FL/Key-
board P.C. Board, Tube P.C. Board (1)/(2),
Remote P.C. Board, Pre-Heat SW. P.C.
Board, Head-Phone Jack P.C. Board, Fade
P.C. Board.
(2
~~
(5
~
(7
~
2. FOYEAANOKALA
(1)
EBeALKER,
FA
AZ
bvVARA-TFYL,
best
AAVEKAOAACALED.
(5
BR)
(2) NIRA VFYVEEALET, (5M)
(3) FHAZALES. (6 Mi)
tt) KHAEATEH, SSVI 4 Vv — (29P) 258
BLABVOCTHERLTFSWs,
(4) 380OAY (OFM) EMXLED. (7H)
(65) 2HPO7ZY7AEALEF. (6 SHA)
(6) FL/Key Board i * Tube #4 (1)//(2) - Remote 4
4% * Pre-Heat SW £4 - Head-Phone Jack HRIALD
ERMDSIEMSETOIAV-ERXLET.
(7) WMEC7aY b-SAVId FL/Key Board 4 Tube #
#R(1)//(2) « Remote 4K - Pre-Heat SW 2£i& + Head-
Phone Jack Si - Fade BROBBRA HT 372 KET
AT CEBCEET,
—-6-
Figure 4 <4 [>
Power Supply P.C. Board
Front Pane!
Tray Panel
Figure 5 (5 [Xp
Power Switch
FL/Key P.C. Board
Tube P.C. Board (2)
Pre-Heat SW
P.C. Board
Solder (A)
Hook (A)
Main P.C. Board
Figure6 <6 [XD
Power Suply P.C. Board
vi al Panel
©) ©)
Buttom Case Figure? <7

Luxman D-105U Specifications

General

Brand	Luxman
Model	D-105U
Category	CD Player
Language	English