As the protection switch for the main power of electric scooter, the air switch will automatically disconnect to ensure safety when
the scooter circuit is abnormal or the current caused by short circuit exceeds the set safe value.
Before open the key, please turn ON this Air switch in advance.
Open the small cap on the top of battery case,plug the battery cable
inside the socket,connecting the battery with scooter.
Unlock and Remove the battery case
Open the saddle,rotate the plug,unplug the power cable connecting with battery,
then pull up the battery case with one hand.
Whether the handlebar is stable and flexible when turning.
Whether the switches on the right and left handlebars can work normally.
Whether the speed accelerator can work normally.
Make sure the tire pressure is normal. The suggested tire pressure is 26-29psi for front wheel and 29-32 psi for rear wheel.
Check tire surface for cracks, damage, wear, and foreign matter puncture or attachment
Whether the tread depth is suffcient (>0.8 mm).
Whether any fault warning light on the instrument panel goes on after being powered.
Whether the battery is fully charged.
Whether the head and tail lights, brake lights and winkers can work normally.
Whether the horn can work normally.
Whether the rear mirrors are clean. Adjust them to the appropriate angle.
Whether the brake oil is suffcient, and whether the handlebars and brake system can work normally.
For any abnormality or operational concern, please contact local Customer Service Center.
NOTES：In order to protect your safety, please turn off the air switch when
cleaning, storing the scooter for a long time, or re- moving the battery pack.
1
2
3
Air switch ON/OFF
Operation of Air switch
Checks Before Riding
9 10
OPERATION GUIDE RIDING GUIDE
1
2
3
4
5
6
7
8
9
10
11
12
Make sure to check the following items before riding a Electric Scooter, which will guarantee your safety on the road.
To Next Page
Loading...
Need help?
General
