Page 32
6.10 Reset all Functions
Like the reset jumper, this function allows you to delete the control unit memory. While the reset
jumper retrieves the control unit to its factory defaults, this function does not delete any detector
and/or accessory that was already learned by the system.
Press ,display changes to flashing.
Press ,display changes to .
Press ,display shows .
Press , wait 2 seconds. Triple click on the
store button will generate an OK beep. The system retained its factory default.
Or
Press ,to return display shown “Standby” mode and without retaining recent settings.
Remember to change both the user and the engineer pincodes and the secondary as well if
validated.
Section 7 – Maintenance
Once every 3 months:
Test all detectors.
Test siren and strobe.
Additionally, once every two years:
Replace all batteries in cordless detectors.
Additionally, once every four years:
Replace the rechargeable battery in the control unit.
Program
1 11 1
09
RESET
Store Store
Store
To Next Page
Loading...