Lynx L15ICE User Manual

Lynx L15ICE 14
12) Move the control switch to the "WASH" posion to circulate clean water for about 5 minutes.
13) Move the control switch to the "OFF" posion, then remove the water tank, drain it, and replace it as described
in 3) through 6).
14) Repeat 12) and 13) three more mes to rinse thoroughly.
Sanizing Soluon
Dilute 0.5 . oz. (14.8 ml or 1 tbs) of 5.25% sodium hypochlorite soluon (chlorine
bleach) with 1 gallon (3.8 l) of warm water. Using a chlorine test strip or other method,
conrm that you have a concentraon of about 200 ppm.
Sanizing Procedure
The sanizing process will sanize the icemaker.
1) Move the control switch to the "OFF" posion.
2) Open the bin door and remove ice from the
storage bin.
3) Remove the slope by bending its center
carefully and releasing it from the two slope
shas. Remove the slope from the storage bin.
4) Thoroughly clean and sanize the storage
bin, slope, scoop and any parts normally
accessible from the storage bin.
5) Remove each separator by liing it to the
horizontal posion and pushing it hard
inward. Remove all separators in the same
way and clean and sanize them.
6) Disconnect the sucon tube by
compressing both plasc tabs to unlock the
joint in the direcon of the black arrows and
pulling the tube clear to drain the tank.
IMPORTANT
For safety and maximum eecveness, use the soluon immediately aer diluon.
Cleaning and Care Procedures
L15ICE

Lynx L15ICE Specifications

General

Brand	Lynx
Model	L15ICE
Category	Ice Maker
Language	English