Lynx LHEM48 User Manual

24
|
CARE & USE/INSTALLATION
AIR TEMPERATURE LIMIT FUNCTION
When using the heater with the remote control
transmitter, always keep the remote transmitter by your
side, i.e., at the same place that you are sitting. This will
assure that the temperature and thermostat function
will always be reading the same temperature that you
are experiencing. Do not leave the remote transmitter
outside or exposed to the elements when not in use. Do
not leave the transmitter facing the sun, or in a place that
allows the transmitter to measure the temperature of the
sun. This could falsely raise the ‘air’ temperature that the
transmitter is reading. Once the ‘room’/air temperature
reaches 95F degrees, the system will automatically shut
the heater off. When the heater is turned on in either the
MANUAL ON or THERMOSTAT ON mode, once the air
temperature becomes 95 degrees, the heater will cycle
automatically to the MANUAL OFF mode. If the user
turns the control back ON, and the air temperature is still
95F degrees or greater, the transmitter will switch back to
MANUAL OFF.
THERMOSTAT DISABLE FEATURE
If, after using your heater, you decide that you do
not want to use the THERMOSTAT function, you can
disable this function on the remote transmitter. When the
THERMOSTAT mode is disabled:
• The Modes of operation will cycle between MANUAL
ON and MANUAL OFF (omitting THERMO).
• Program Operation (described below) is also disabled.
• The SET TEMP zone will be blank.
• The air temperature will still be measured & displayed
in the ROOM/AIR TEMP Zone.
• The TIME/PROG zone will continue to display
the Clock and Day of week, but none of the icons
associated with Program Mode will be displayed.
• To disable or re-enable the Thermostat, the
transmitter must be in MANUAL OFF Mode, then press
and hold the SET TEMP Zone and the DOWN Button
simultaneously for 10-seconds. The entire contents
of the LCD screen will flash 3-times (0.5-seconds OFF,
0.5-seconds ON) to indicate the change has been
made.
TOUCH SCREEN REMOTE CONTROL...continued

Lynx LHEM48 Specifications

General

Brand	Lynx
Model	LHEM48
Category	Heater
Language	English