44
ENGLISH
1. Hook up starter clip
1
. Clip
Pull the rope using a sharp, crisp pull so the rope comes free of the drive pulley. Start the
engine as per usual manual starting.
When starting the snowmobile in an emergency situation, using drive pulley, do not reinstall
the belt guard and return slowly to have snowmobile repaired.
Shutting off the engine
Release throttle lever and wait until engine has returned to idle speed.
Shut off the engine using either ignition switch, engine cut-out switch or tether cut-out switch.
Always remove tether cord cap and key when vehicle is not in operation in order to
prevent accidental engine starting or to avoid unauthorized use by others or theft.
WARNING!
To Next Page