64
ENGLISH
1. Air filter installed on top of air silencer
Check that the air silencer is clean and dry and properly reinstall the filter.
CAUTION: Snowmobile have been calibrated with the filter installed. Operating the
snowmobile without it may cause engine damage.
Bulb replacement
Always check light operation after bulb replacement.
CAUTION: Never touch glass portion of an halogen bulb with bare fingers, it shortens
its operating life. If glass is touched, clean it with isopropyl alcohol which will not
leave a film on the bulb.
Some models: If headlamp bulb is burnt: Remove headlight moulding and windshield, un-
plug the connector from the bulb, remove the protector cap and bulb retainer clips. Install
new headlamp bulb.
Some models: If the headlamp bulb is burnt: Remove windshield and headlamp moulding, unplug
connector from headlamp, remove protector cap and turn bulb off, install new headlamp bulb.
Instruments
Bulb socket is always behind the instrument under a black rubber boot. Pull rubber boot and
pull bulb out of socket.
Headlamp beam aiming
Turn knob to adjust beam height.
1. Knob
To Next Page