Need help?Do you have a question about the Lynxspring LYNX-WD-007-01 and is the answer not in the manual?
General| Brand | Lynxspring |
|---|---|
| Model | LYNX-WD-007-01 |
| Category | Monitor |
| Language | English |
Provides instructions for installing the Lynxspring Touch Screen Display.
Intended for competent persons with minimal IT skills; do not install without relevant experience.
Mount on panel or back box, requires single-phase feed (Live, Neutral, Earth).
For wired Ethernet, use Cat5 cable fed into the box and snap-locked to the adapter.
Connect microUSB and 2.5mm Barrel cables to the tablet's power socket.
Mount display frame over plate using grooves and grub screw.
Secure grub screw and use Allan key to power up the screen.
Use 1:1 template to mark and drill mounting holes on the panel.
Attach plate and PSU using screws and washers.
Fit grommet, make connections, attach converter, follow Setup Guide.
To Next Page