SHELVING ACCESSORIES
Half Shelf Clips
Foot Plate – Angle and Beaded Post
Attach Angle Post with ¼-20 x 5/8” truss head
screw and nut. Attach Beaded Post with ¼-20 x
1” truss head screw and nut. Floor anchors are
not supplied with foot plates. *
NOTE: When factory welded uprights are used,
field drill bottom hole of angle post for footplate.
End Base
Attach to posts with Tinnerman Nuts #702517
and #10 x 1/2” truss head sheet metal screws.
Angle Divider
Attach to Series 2000 shelf with #12-24 x 3/8”
truss head screws and nuts.
Front Base - Angle Post
Attach to face of box shelf with (3) #701487
Panel Clips. Half Shelf Clips are furnished
with 1-1/2” bases.
Label Holder
Attach to Series 2000 Shelf With (3) #701487
Panel Clips.
Front Base – Beaded Post
Attach to face of box shelf with (3) #701487
Panel Clips. Half Shelf Clips are furnished
with 1-1/2" bases.
Shelf Divider
Attach to Series 2000 shelf with #701487 Plastic
Panel Clips. When installed, front edge of divider
is 5/8” back from front edge of shelf.
Shelf Box Guide
Attach to Angle Post with ¼-20 x 1” truss head
screws and nuts.
* Lyon recommends securely anchoring all shelving.
To Next Page
Loading...