LYRIC RUN3R - Handlebar and Battery Installation; Unfold and Secure Handlebar; Insert and Lock Batteries

6
 2.2unfoldHandlebaR
beWaReofPinCHPoint

Fold up stem with attached handle bar (1) so that the center guide (A) and the stem align parallel
to the cylinder (B) below.

Push in safety lock button (2) fully and push down the stem at the same time until the safety
lock button pops out again (3).

Pull the stem up again to check if the stem sits firmly on the cylinder; the stem should not move
up or down and the safety lock button should sit correctly in its proper position (4).
Adjust counter nut (5) of the quick release until you feel a strong pressure when closing the quick
release (6) and you are able to rmly push it down onto its arrester (7).
 2.3foldHan-
dlebaR

Follow steps 6–1 from previous
section to make sure that the
safety lock button (2) is
pushed in all
the way before pulling up the
stem.

Note: Be careful not to bend the center guide (A).
 2.4inseRtbatteRies
5 6 7
1 2 4
a
b
3