8
Transport Controls
Axiom AIR's transport controls allow you to perform the following operations in your Cubase session:
• Play: Press Play to start playback.
• Stop: Press Stop to stop recording or playback.
• Record: Press Record to start recording on all record-enabled tracks.
• Rewind: Press Rewind to move the audio pointer's current position backward. Press it again to
stop it.
• Fast Forward: Press Fast Forward to move the audio pointer's current position forward. Press
it again to stop it.
• Return to Zero: Hold the Loop button down and press Rewind to jump to the beginning of
your session.
• Skip to End: Hold the Loop button down and press Fast Forward to jump to the end of your
session.
• Undo: Hold the Loop button down and press Stop to undo or cancel the last operation in
Cubase (the same as selecting Undo from the Edit menu).
• Cycle On/Off: Press the Loop button to activate or deactivate Cycle Mode (playback will loop
in the region set by the left locator and right locator positions in Cubase's transport).
To Next Page
Loading...
