To Next Page

To Previous Page

Torq MixLab User Guide » Chapter 1

Torq MixLab User Guide » Chapter 5

When a mis-alignment occurs (as seen above), you’ll see that the grid does not line up with the beginnings of the beats

(transients) in the waveform. In the example, the Phase Grid is too early, leaving a gap between the grid lines and the

transients in the waveform.

There are a number of ways to ﬁ x a mis-aligned Phase Grid. Which method you choose to use will probably depend on

whether you’re comfortable using the mouse and keyboard, or whether you prefer to use external MIDI control. The results

are all the same, so choose whichever feels good for you.

Adjusting with the Mouse

1. Hold down the Shift key, then click-and-drag left or right with the mouse.

2. The Phase Grid will move left or right, following your mouse movements.

3. Once you have aligned the thicker “downbeat” marker of the grid to the downbeat of the music, release the

mouse button.

Note: You can turn on Caps Lock instead of holding Shift if you need to adjust the grid using just one hand. Turn

off Caps Lock when you’re ﬁ nished so you can regain proper control of the waveforms.

Adjusting with Nudge Buttons

1. Hold down the Shift key, then click on one of the Nudge buttons.

2. The Phase Grid will move left or right depending on which Nudge button you click.

3. Use the buttons to align the thicker “downbeat” marker of the grid to the downbeat of the music.

Adjusting with Offset Buttons

1. Hold down the Shift key, then click on one of the Offset buttons.

2. Instead of making a small change to the Phase Grid, this will have the effect of moving the grid an entire

beat left or right. This is a quick way to ﬁ x the Phase Grid if it happens to be aligned to the beats but has the

downbeat in the wrong location.

M-Audio Digital DJ System User Manual

Questions and Answers: