M-Audio Firewire Audiophile

11 When the installation is complete, click “Shut Down” to complete the wizard.
After the computer has powered off, plug the FireWire Audiophile into your
computer’s FireWire Port and power it on. Once the FireWire Audiophile is
connected, turn on your computer.
12 Once the operating system loads, go to "System Preferences" in the Apple
Menu. Select the "Sound" preference panel, and click the "Output" tab. Select
"M-Audio FireWire Audiophile" to choose the FireWire Audiophile as your default
output device.
Mac OS9
NOTE: Never connect or disconnect the FireWire Audiophile while the computer is on.
Also, if you’re going to use bus power, we recommend that you connect the FireWire
cable before turning on the FireWire Audiophile’s power button.
To use MIDI on the FireWire Audiophile, you must first install Opcode’s OMS before
installing the FireWire Audiophile driver software. OMS can be installed from the Driver
CD by opening the OMS 2.3.8 folder, and then double clicking the OMS installation icon.
After you have installed OMS, follow these instructions to install the FireWire Audiophile
driver software.
1 Insert the Driver CD-ROM into your CD-ROM drive and open the CD-ROM to
view its contents. Locate and open the “FireWire AP” folder, then open the folder
for OS 9.