13 Product Specs
A to D & Line In 1/2
Max Input (output) +2dBV
SNR 102dB A-weighted
Dynamic Range 101dB A-weighted
THD+N 0.0015% (-94dB)
Frequency response, 48kHz sample rate +0.10/-0.20dB, 20-20kHz
Frequency response, 96kHz sample rate +0.10/-0.25dB, 20-40kHz
Input/output Impedance 11k-ohms
D to A & Line Out 1/2
Max Input (output) +2dBV
SNR 106dB A-weighted
Dynamic Range 108dB A-weighted
THD+N 0.0020% (-96.5dB)
Frequency response, 48kHz sample rate +0.0/-0.16dB, 20-20kHz
Frequency response, 96kHz sample rate +0.25/-0.55dB, 20-40kHz
Input/output Impedance 100 ohms
Line Out 3/4
Max Input (output) +2dBV
SNR 104dB A-weighted
Dynamic Range 108dB A-weighted
THD+N 0.0015% (-96.5dB)
Headphone Out (@ maximum gain)
Max Input (output) +9dBV
SNR 103dB A-weighted
Dynamic Range 105dB A-weighted
THD+N 0.0050% (-86dB)
Default Mixer Settings:
• Mixer faders – set to 0 dBfs
• Output faders – set to 6 dB attenuation
• Output channels - assigned to “main”
• Headphone source - set to “1/2”
• Software Return channels – routed as follows: sw rtn 1/2 to output “1/2”,
sw rtn 3/4 to output “3/4”, sw rtn spdif to output “spd”
• “Aux Send” knobs - set to full attenuation
• “Analog in” and “spdif in” – no routing assigned
• “Pan” knobs - set to hard left and right
• “Balance” knobs - set to center <C> position
• Channels - set to: mute=off, solo=off & link=off
• Level Controller – assigned to “output” fader group (all channels in group will be selected)
To Next Page
Loading...
