6 Select your install location, or just choose the default, OS 9 boot drive. Click “Choose.”
7 A notice will appear advising that the computer will need to be restarted. Click
“Yes” to proceed.
8 You will be prompted to shut down your computer. Click ”Shut Down.”
9 When your computer has powered off, connect the FireWire Audiophile to your
computer’s FireWire port and turn it on. Once the FireWire Audiophile is
connected, turn on your computer.
10 After the operating system loads, enter the Control Panels under Apple Menu,
and select “Sound.” Then select the “Output” tab. Click on M-Audio FireWire
Audiophile to select FireWire Audiophile as your default audio device.
First Time OMS Configuration Instructions:
Go to the Control Panel or Chooser under the Apple Menu, and make sure AppleTalk is
turned off (this is recommended, although OMS will sense that it is on and prompt you to
turn it off). If you are installing your FireWire Audiophile driver and configuring OMS for
the first time, follow these instructions to configure OMS.
1 In the Opcode folder that you will find on your hard drive, locate the OMS
Applications folder, then OMS Setup. Double click on OMS Setup. (OMS setup
can sometimes be done from within your music application.)
2 OMS will inform you that it has not yet been configured. Click “OK.”
3 The Create A New Studio Setup dialog box now appears. Click “OK.”
4 The "OMS Driver Search" box asks you to choose the port on which you've
attached the FireWire Audiophile (either Modem or Printer). DO NOT choose a
port. Just click "Search." OMS begins searching. IMPORTANT: If the FireWire
cable is not correctly connected to the FireWire Audiophile, setup will fail.
To Next Page
Loading...
