23
Click-hold the Sync Button in either Transport area.
In the flip menu that appears, choose “Open Tempo Sequence”.
Change the SMPTE time position of the first (usually the only) tempo
event to your desired start time (e.g.. 0: 0: 5: 0/ 0).
Special Note on the Tascam 238 Tape Deck
On the back of the Tascam 238 are two switches marked “Tape Sync”
and “Filter.” Contrary to the instructions given in the Owner’s Manual
these switches should be set as follows: “Filter” switch to OUT - so the
mid range filter is NOT active; and “Sync” switch to IN - so you can
adjust the recording level to around -5 dB.
To Next Page
Loading...
Need help?
General
