5
Features
Top Panel
Octave/Wheels
1. PITCH: This wheel creates expressive changes in
performances by raising and lowering pitch.
Rolling the Pitch Bend wheel upward will raise an instrument’s
pitch whereas rolling it downward will lower the pitch.
The upper and lower pitch bend limit is determined by settings
on your hardware or software synthesizer, not by the Pitch
Bend wheel on the Oxygen 25 keyboard itself. Typically, this
can be either a half note or an octave up/down.
This wheel is spring mounted and will return to the center
detent position when released.
2. MOD (Modulation): This wheel is used to add expression to
performances by changing the intensity of certain effects.
By default, most synthesizers assign this wheel to control
vibrato (change in intonation) or tremolo (change in volume)
although it is usually possible to reassign the function of this
wheel through the instrument’s control panel.
Rolling the Modulation Wheel upward will increase the modulation effect, while rolling downward
will reduce the effect.
The Modulation Wheel is an assignable controller capable of sending a variety of MIDI messages
other than Modulation data.
3. OCTAVE - / +: The Octave buttons are used to shift the keyboard’s octave range up or down in
one octave increments, extending the octave range of the pads or keys.
TRANSPOSE: Hold SHIFT and press either of these buttons to transpose the keyboard up or
down.
VOICING TYPE
To Next Page
Loading...
Need help?
General
