M-Audio OXYGEN 49 MKV - Tempo Control; Note Repeat;Latch Button; Presets

22
Tempo Control
To edit the Tempo button, press the Tempo button. You can either repeatedly tap the TEMPO
button to enter in the tempo, or press and hold the TEMPO button and use the < and >
Buttons to scroll to your desired tempo.
SYNC: Pressing the Shift Button and the Tempo Button selects whether the tempo is sent
from the keyboard’s internal tempo or synced to an external DAW.
Available Values: Internal, External
BPM ###.: 20.00 – 240.00
Note: Clock messages are sent and received on Oxygen Port 1 (Oxygen ##/USB MIDI).
Note Repeat/Latch Button
When this button is pressed and held it will activate the Pad’s Note Repeat/Roll functionality.
If SHIFT and this button are pressed together, then that will activate the Note Repeat button’s
Latch feature.
While Note Repeat is active, in Preset Mode the < and > Buttons can be used to change the
current Time Division setting of the Arpeggiator and pad Note Repeat. Time Division
settings can also be changed when the ARP is active by pressing and holding the SHIFT
Button and pressing the keys labeled with Time Division settings.
• 1/4
• 1/4T
• 1/8
• 1/8T
• 1/16
• 1/16T
• 1/32
• 1/32T
Presets
A preset is a saved collection of assignments for your Oxygen’s controls, channel settings,
keyboard zone settings, etc. You can store up to 10 Preset presets in Oxygen 25, 49 and 61’s
internal memory, enabling you to use a dedicated preset for each virtual instrument, or
project/session.
We recommend registering your Oxygen on m-audio.com and downloading the Oxygen
Series Software Manager.
In the Software Manager you'll have access to all of your included software as well as the
Oxygen Preset Editor. The Preset Editor gives you a visual and intuitive way to edit the
various messages that Oxygen’s controls send to your computer without having to use the
hardware interface. The Preset Editor enables you to save and load custom presets from your
computer.
To select a Preset preset on the Oxygen, press the DAW/PRESET button to put the
keyboard in Preset Mode (DAW button unlit), and use the < and > Buttons to select your
desired preset.
To select a DAW preset on the Oxygen, press and hold the DAW/PRESET button when in
DAW mode (DAW button lit), and use the < and > Buttons to select your desired DAW preset.