24
To set the keyboard to operate in DAW Mode, press the DAW/Preset Button so that the
DAW button is lit.
To change which DAW your keyboard is set to control:
While in DAW mode, press and hold the DAW/Preset Button and then use the < and >
Buttons to select your DAW.
Most DAWs will automatically recognize the Oxygen series keyboard, and automatically
configure your Oxygen’s controls as a control surface in DAW mode, and virtual instrument
controller in Preset mode.
If your DAW does not automatically configure your Oxygen series keyboard, please follow the
setup steps listed in the Oxygen DAW Setup Guides.
To set the keyboard to operate in Preset Mode, press the DAW/Preset Button so that the
DAW button is unlit.
To change the currently selected preset:
To select a Preset preset on the Oxygen, press the DAW/PRESET button to put the
keyboard in Preset Mode (DAW button unlit), and use the < and > Buttons to select your
desired preset.
There are Presets for all of the Virtual Instruments included with your Oxygen. For Virtual
Instruments that are not included with your Oxygen, we suggest using MPC Beats as a plugin
wrapper in your favorite DAW, and the Oxygen’s MPC PI preset. MPC Beats opens as a
plugin wrapper in all mainstream DAWs to merge the best of all DAW worlds. This gives you
the freedom to use MPC Beats as a soft synth/Virtual Instrument plugin wrapper, enabling you
to have all of your Oxygen controls auto-mapped to your favorite soft synth/Virtual Instrument
plugin.
To download the included MPC Beats software, follow the instructions on the included
software download card.
SHIFT Button
When this button is pressed and held it will enable you to select SHIFT modifier functions of
the keyboard.
To Next Page
Loading...
