M-Audio OXYGEN PRO 25

87
Fader Buttons
To edit one of the Fader Buttons when in DAW Edit Mode, press a fader button. After you’ve
selected which button you would like to edit you will need to select what button you are
editing per Mode. This enables you to have 4 different button messages for 1 button
depending on the MODE – Rec, Select, Solo and Mute. For example, fader button 1 can send
a CC message on channel 1 when MODE is set to Record, and then when the MODE is set to
Select fader button 1 can send a CC message on channel 2. You can scroll through the
available parameter values using the Encoder. Select what parameter you would like to edit by
pressing the Encoder.
Mode “MODE”:
• Record
“RECORD”: The fader button’s message when the MODE is set to RECORD.
• Select
“SELECT”: The fader button’s message when the MODE is set to SELECT.
• Mute
“MUTE”: The fader button’s message when the MODE is set to MUTE.
• Solo
“SOLO”: The fader button’s message when the MODE is set to SOLO.
Channel: The fader button will send its messages over this channel. Select the global channel
(Global), or a specific channel (Channel 1–16).
Available Values: Global, 1-16
Message “MESSAGE”:
• Mackie/HUI “MACK/HUI”: When set to Mackie/HUI, you can use the button with a DAW
that responds to HUI mode’s Rec, Select, Mute, and Solo controls.
• Mackie “MACKIE”: When set to Mackie Control, you can use the Encoder with a DAW
that responds to Mackie Control mode’s Rec, Select, Mute, and Solo controls.
• Program
“PROGRAM”: The fader button will send this program number when you press
it.
• Program Cycle
“PRG CYCL”: The fader button will send the value with this Program
number when you press it, one at a time, cycling through them with each press.
• Program Inc/Dec
“PG IN/DC”: The fader button will send the next (Increment) or previous
(Decrement) program number in the range of programs when you press it.
• CC
“CC”: The fader button will send its MIDI messages using this CC number.
• CC Cycle
“CC CYCLE”: The fader button will send the value with this CC number when
you press it, one at a time, cycling through them with each press.
• CC Inc/Dec
“CC INC/DC”: The fader button will send the next (Increment) or previous
(Decrement) value number in the range of values when you press it.
• Note
“NOTE”: The fader button will send its MIDI messages using this Note number.
When set to Program, these are the available parameters:
Program: The fader button will send this program number when you press it.
Available Values: 0-127
MSB: The fader button will send this Bank MSB (Most Significant Byte) number when you
press it.
Available Values: 0-127