11
Appendix A - Technical Specifications
Type: Two-way studio reference
LF Driver: 4-inch dia., magnetically-shielded with curved cone, high temperature voice
coil and damped closed cell foam surround.
HF Driver: 1-inch dia., magnetically-shielded with specially shaped mylar dome
Frequency Response: 70Hz - 20kHz
Crossover Frequencies: 2.2kHz
RMS SPL: 101.5dB @ 1 meter
Dynamic Range: >95dB
S/N Ratio: >90dB (typical, A-weighted)
Input Connectors: Left and Right RCA Line Input connectors, Left and Right TRS
balanced/unbalanced input connectors.
Polarity: Positive signal at + input produces outward low-frequency cone displacement
Dynamic Power: 18 watts/ 4 ohms with 2 channels connected
Input Impedance: 20k ohms balanced, 10k ohms unbalanced
Input Sensitivity: 100 mV pink noise input produces 90dBA output SPL at 1 meter with
volume control at maximum
Protection: RF interference, output current limiting, over temperature, turn on/off
transient, subsonic filter
Indicator: Blue power LED on front panel
Power Requirements: 120V/~60Hz, 230V/~50Hz or 100V/50Hz/60Hz; powered via
detachable 2-circuit line cord
Cabinet: vinyl-laminated MDF
Dimensions: 8.5 inch (H) x 5.75 inch (W) x 6.25 inch (D)
Weight: 12 lbs./pair (approx., without packing)
* Above specifications subject to change without notice
To Next Page
Loading...