Product Controls and Indicators: Instructions for Use:
1) Turn temperature and speed to zero before plugging in. And connect the Main power cord to
should be placed in center of hot plate
2) Place your container or heating bath with magnetic stirrer bar. Stirrer bar should be placed in
Center of hot plate.
3) Turn Power Switch ON
MS300HS,MS200
1. Fill vessel with solution to be stirred.
2. Place stir bar into vessel.
3. Place vessel in the center of the top surface.
4. Turn power switch ON. Then Hot Top Indicator Lamp will illuminate.
5. Turn Stir Control Knob until the desired speed.
6. Speed On Indicator Lamp will illuminate when the motor runs.
7. Heating and stirring can be performed simultaneously on the MS300HS models which offer
both heating and stirring functions.
8. When the desired stirring is complete, turn the Stir Control Knob to “0” position. Allow stir
bar to cease rotation before removing the vessel from the unit.
9. Disconnect Main power cord from the unit.
10. Keep the product dry and clean disconnecting Main power cord when the unit is not used for a long time.
Note:
1) Range of speed control : 100~1500 RPM
3) If motor does not run upon turning the knob, increasing until 100rpm or more
Please note that the viscosity of the stirred material will affect the ability of the stir bar to remain
coupled to the rotating ring magnet. Materials of high viscosity must be stirred at slower speed
settings
To Next Page
Loading...
