M-VAVE IR BOX - Page 5

4
① Power inteace: use 9V1A DC transformer (Positive inside and
negative outside).
② USB inteace: Suppo 5V power supply, it is recommended to
use the 5V 1A adapter.
③ Headphone po: Suppo the use of 3.5mm headset.
④ LOW CUT knob: Adjust the frequency point of the global low
frequency shear, adjust the whole 32 preset output timbre. The
shear range is 20 HZ-360 HZ (Turn the knob counterclockwise to the
end of 20HZ, that is, the low frequency below 20HZ is cut. Turn the
knob clockwise to the end of 360HZ, that is, the low frequency
below 360HZ is cut out.）
⑤ HI CUT knob: Adjust the frequency point of the global high
frequency shear, adjust the whole 32 preset output timbre. The
shear range is 18 kHZ-1 kHZ (Turn the knob counterclockwise to the
end of 18kHZ, that is, high frequencies above 18kHZ are cut. Turn
the knob clockwise to the end of 1kHZ, that is, high frequencies
above 1kHZ are cut.）
⑥ VOL knob: Adjust the total output volume of IR BOX, and the
external audio volume through USB input is uncontrollable.
⑦ Left button: Select the preset forward. Press the left and right
button to enter the BYPASS state.
LOW CUT HI CUT
VOL
OU T
IN
I
I
I
BYPASS
XLR
① ② ③
④ ⑤⑥
⑦ ⑧
⑩
⑨
⑪
⑫