MA 2Port Node WM - Configuration Management; Saving and Loading Settings

MA 2/4 Port WM
Data
Transport
Safety
instructions
Safety and
environment
Quickstart
Connect
Quickstart
ON / OFF
Maintenance
Conformity
39
Save Configuration /settings
You can save the settings of MA 2/4Port Node only the hard drive of a grandMA2 console.
 Open menu SETUP / NETWORK / MA NETWORK CONFIGURATION / DMX NODES and press button SAVE
TO DEFAULT.
NOTE: With command SAVE SHOW settings of the MA 2/4Port Node are not stored; settings must be stored with
SAVE TO DEFAULT!
Load Configuration /settings
Open menu SETUP / NETWORK / MA NETWORK CONFIGURATION / DMX NODES and press button LOAD
FROM DEFAULT
If you have integrated additional 2/4Ports into the Show or exchanged a 2/4Port, after having saving the
configuration, these 2/4Ports will not be taken into account when loading this configuration (even if the IP address
wasn’t changed). You will first have to configure these „new“ 2/4Ports and then create a new configuration file
using SAVE CONFIG.