MA Digital Dimmer - 2. Quick Manual; Function and Controls

MA Lighting Technology GmbH
.
Dachdeckerstr. 16
.
D-97297 Waldbüttelbrunn
.
Fax: +49 931 4979429
.
www.malighting.de
44
44
4
SIEMENS SIEMENS SIEMENS SIEMENS SIEMENS SIEMENS SIEMENS SIEMENS SIEMENS SIEMENS
SIEMENS
SIEMENS
MENU
DIGITAL DIMMER 12 2.3kWx
12345 6789101112
C10 C10 C10 C10 C10 C10 C1 0 C10 C10 C10 C10 C10
2. Quick Manual / Function and Controls
LCD Display
Magnetic Circuit Breaker C10 or C16, slow trip
Encoder (Data Wheel)
left "soft" button
with red LED
right "soft" button
with red LED
"menu" button (swich to the next menu)
with green LED
Quick Manual for people in hurry:
Before switching the dimmer on connect the load control cables.
- If the dimmer is delivered ex work and used with analogue input, it is not necessary to make
any adjustments.
- If the dimmer is delivered ex work and used with DMX input, please press the Menu button
(middle) under the display once. Now the channel menu appears, where the DMX start address
can be set. To do that keep the right button pressed down and adjust the DMX start address with the
encoder.
- If the Dimmer is not delivered ex work, but e.g. is returned from a rental, all storages should be
cleared and set to default values:
To activate this powerful function please read chapter 4.4 resp. 4.4.7.
Basically the menus and softkeys work as follows:
The three "basic menus" can be selected one after the other by the middle button.
The encoder can be turned with or without simultaneously pressing a button; the functions will be
different in the various menus.
Programming is only possible by pressing a button and turning the encoder at the same time.