MA grandMA3 Installation

1
Hint:
The grandMA3 I/O Node can be connected with the power cable. Only the grandMA3 I/O Nodes DIN-Rail need to be
installed on the rail following DIN EN 60715 and the instructions below.
Important:
Install the grandMA3 I/O Node DIN-Rail horizontally so that the input terminal is located at the bottom.
Warning:
In order for the device to dissipate heat, comply with a minimum distance of 30 mm (approx. 2 inches) above and
beneath the grandMA3 I/O Node DIN-Rail.
1
Installation

MA grandMA3 Specifications

General

Category	Lighting Console
Manufacturer	MA Lighting
Model	grandMA3
Type	Professional lighting control console
HIPS	Yes (High-Performance Processing System)
Ethernet connectors	2x Ethercon/RJ45
TFT multi-touchscreen	1 internal
External monitor ports	1x DisplayPort 1.2
DMX outputs	1x (XLR 5pin)
DMX inputs	1x (XLR 5pin)
Processing Unit	High-performance CPU and GPU
Storage	SSD (varies by model)
Display	1 internal TFT multi-touchscreen
Connectivity	2x Ethercon/RJ45, 1x DisplayPort 1.2, 1x DMX output (XLR 5pin), 1x DMX input (XLR 5pin)
Dimensions	Varies by model
Weight	Varies by model
DMX channels	16, 384 (grandMA3 onPC command wing XT); 4, 096 (grandMA3 onPC command wing)
Fixtures	Unlimited (limited by processing power)
Cues	Unlimited (limited by storage)
Cue lists	Unlimited (limited by storage)
Presets	Unlimited (limited by storage)
Groups	Unlimited (limited by storage)