mabe aqua saver - Filling Hose Installation; Connecting Filling Hoses

46
Cold water hose
Hot water hose
In the event of having only cold water you can choose this option.
Requirements
Filling hoses
Before connecting your washing machine to the water tap, open the feeding faucets and
let the water flow for a few minutes (enough to clean the pipes and ensure no
obstructions).
Install the hoses as shown in the figures. Make sure to tighten the connections enough to
prevent water leaks.
Due to impurity of the water and
piping conditions from the supply
network of the Water Supplier in your
neighborhood, we recommend that you
clean the gasket filters once a month.
Make sure you install the filling hoses
provided with your washing machine.
Avoid using used or deteriaorated hoses.
The connection hoses have connectors at each end, one black and the other gold. The
connector must be installed to the water tap of your house and the gold one to the water
inlet of your washing machine.
We recommend that you use the provided Y - type
adaptor connecting both hoses to the water inlets of
your washing machine.
1. Place the Y adaptor on the water tap of your
house.
2. Connect the hoses to each end of the Y
adaptor.
3. To prevent water leaks be sure to perfectly
place the rubber gaskets of the hoses and the Y
adaptor.