mabe CLME71214BAT - Dryer Venting and Cleaning; Proper Venting and Exterior Cleaning

22
This dryer must be exhausted to the outdoors.
Use only 4” rigid metal ducting for the home exhaust duct.
Use only 4” rigid metal or UL-listed dryer transition duct to connect the
dryer to the home exhaust.
do not use a plastic vent.
do not exhaust into a chimney, kitchen exhaust, gas vent, wall, ceiling,
attic, crawl space, or concealed space of a building.
do not install a screen in or over the exhaust duct.
do not install a booster fan in the exhaust duct.
do not use duct longer than specied in the exhaust length table.
Failure to follow these instructions can result in death or re.
Clean lint
from mesh
Clean lint
from mesh
warning
- re hazard
correct
venting
incorrect
venting
venting - dryer
venting the dryer - For the best drying performance, the dryer needs
to be properly vented. The dryer will use more energy and run longer if
it is not vented to the specications below. Carefully follow the details
on Exhausting in the Installation Instructions.
Ductwork that runs through an unheated area or that is near air
conditioning should be insulated to reduce condensation and lint build-up.
care and cleaning - dryer
the exterior: Wipe or dust any spills or washing compounds with a damp
cloth. Dryer control panel and nishes may be damaged by some laundry
pretreatment soil and stain remover products. Apply these products away
from the dryer. The fabric may then be washed and dried normally. Damage
to your dryer caused by these products is not covered by your warranty.
the lint lter:
Clean the lint lter
before each use. Slide
out the grid that
covers the lter.
Run your ngers
across the lter.
A waxy buildup may
form on the lint lter from using dryer-added fabric softener sheets.
To remove this buildup, wash the lint screen in warm, soapy water. Dry
thoroughly and replace. Do not operate the dryer without the lint lter
and grid in place. Have a qualied technician vacuum the lint from the
dryer once a year.
This dryer must be exhausted to the outdoors.
Use only 4” rigid metal ducting for the home exhaust duct.
Use only 4” rigid metal or UL-listed dryer transition duct to connect the
dryer to the home exhaust.
do not use a plastic vent.
do not exhaust into a chimney, kitchen exhaust, gas vent, wall, ceiling,
attic, crawl space, or concealed space of a building.
do not install a screen in or over the exhaust duct.
do not install a booster fan in the exhaust duct.
do not use duct longer than specied in the exhaust length table.
Failure to follow these instructions can result in death or re.
Clean lint
from mesh
Clean lint
from mesh
warning
- re hazard
correct
venting
incorrect
venting
This dryer must be exhausted to the outdoors.
Use only 4” rigid metal ducting for the home exhaust duct.
Use only 4” rigid metal or UL-listed dryer transition duct to connect the
dryer to the home exhaust.
do not use a plastic vent.
do not exhaust into a chimney, kitchen exhaust, gas vent, wall, ceiling,
attic, crawl space, or concealed space of a building.
do not install a screen in or over the exhaust duct.
do not install a booster fan in the exhaust duct.
do not use duct longer than specied in the exhaust length table.
Failure to follow these instructions can result in death or re.
Clean lint
from mesh
Clean lint
from mesh
warning
- re hazard
correct
venting
incorrect
venting