Need help?Do you have a question about the mabe GTW485BMKWS and is the answer not in the manual?
Information is for individuals with adequate electrical, electronic, and mechanical experience. Improper repairs can cause injury or damage.
Reconnect all grounding devices properly after servicing to ensure safety and prevent damage.
Service technicians must follow the 6-step LOTO process before accessing washer components.
Procedure to remove the impeller by accessing the center cap and hex bolt.
Steps to remove the dual action agitator by accessing the bolt at the bottom.
Procedure to remove the single action agitator by accessing the bolt inside.
Steps to enter service mode by pressing Start and rotating cycle knob.
Troubleshooting for no signal changes indicating motor turning during spin.
Troubleshooting for extended pressure readings nearing overflow levels.
Troubleshooting for water volume exceeding fill limits, possibly due to stuck valve.
Troubleshooting for differences in pressure sensor readings vs. expected.
Troubleshooting for lid lock blockage or failure to engage/disengage.
Troubleshooting for lid switch failure indicating OPEN and LOCKED simultaneously.
To Next Page
General
