EasyManua.ls Logo

mabe MFT25PVQLG - Troubleshooting

mabe MFT25PVQLG
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
problem
Water dispenser
does not operate.
Water cooler is not
cold enough.
Water dispenser
hot water is not hot
enough.
Compressor
turns on and off
frequently.
Vibrations.
The water dispenser
seems to make too
much noise.
Bottle feels warm.
Water bottle is hot.
possible cause
Notpluggedin.
The circuit breaker tripped or a blown
fuse.
Checktobesurethecoldswitchonthe
backisON.
The water dispenser does not have the
correct clearances.
Checktobesurethehotswitchonthe
backisON.
Theroomtemperatureishotterthan
normal.
Thetemperaturecontrolisnotset
correctly.
The water dispenser does not have the
correct clearances.
Checktoassurethatthewaterdispenseris
level.
Therattlingnoisemaycomefromtheow
oftherefrigerant,whichisnormal.
Aseachcycleends,youmayheargurgling
soundscausedbytheowofrefrigerantin
your water dispenser.
Contractionandexpansionoftheinside
wallsmaycausepoppingandcrackling
noises.
The water dispenser is not level.
Thewatersystemisoverlled.Dispense
Coldwateruntilairisreleasedintothe
bottle.
Water is boiling in the hot tank and
bubblingupintothebottle.Pressthe
hotdispenserbuttonuntilwaterowsto
removeairfromthehottank.
troubleshooting