EasyManua.ls Logo

mabe MFT25PVQLG - Using Your Water Dispenser; First Use Cycles and Setup; Replacing Water Bottles; Hot Water Function Usage Advice

mabe MFT25PVQLG
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
•Plugthedispenserintotheelectricaloutlet.Wearereadytocom-
pletetherstcycle.Inordertodothat,waitforthehotwaterto
reachtemperatureinapproximately10minutes,andthenwaitfor
thecoldtoreachtemperature(another40minutes,approximately).
•Unplugthedispenserfromtheelectricaloutlet.Proceedtodrain
thewaterfromthefaucetsoneatatimeuntilnomorewater
remains.(Note: To facilitate this operation, use a large container).
•Then,drainanywaterleftinthetanksbyopeningthedrainplug
locatedontheback,untilitdrainscompletely.
•Proceedtoclosethedraincap.
•Removethecapfromthe5-gallonbottleanduseacleanclothto
wipe off the neck of the bottle.
•Placethe5-gallonbottleofwateronthewaterintake,allowwater
tostandforapproximatelyoneminute.
•Pushwaterfaucetbuttonstoinsurewaterowsfrombothfaucets.
•Plugdispenserbackintotheelectricaloutlet.
•Nowyouarereadytouseyourwaterdispenser.
NOTE: Your water dispenser has been cleaned and sanitized
before leaving the factory, but in case a taste problem develops,
place two tablespoons of baking soda and add tap water. Fill water
tank again and repeat basic operations previously outlined, except
turn hot water function “OFF” to operation previously outlined,
except turn hot water function “OFF” to avoid leaving residues in
hot water tank.
attention:
If you do not plan to use the water heating function for more
than three days, we recommend that you turn off the hot water
function.
operating your water dispenser
steps to replace water bottles
• Removecap.
• Useacleanclothtowipeoffneckofbottle.
• Carefullyliftbottle(approx.40lbs.)usingyourlegsandnotyour
back.Donotplacehandsonopeningofbottlewhileplacingin
reservoir.
• Insertthewaterbottleonthewaterintakeoverreservoiropening
so it settles properly on it.
• Wipeoffanywaterwhichmayhavesplashedondispensertop.
• Whenanewbottleisinstalledyoumustopenthehotwaterfaucet
andremovenolessthan4fullcupsofwatertoinsurethewater
owsproperlyandthewaterreservoirisattheproperlevel.