Remove the bulb twisting it in the counterclockwise direction.
Replace the bulb with another of the same characteristics and
dimension as the previous one.
Place the bulb cover at the top, slide it down and then push the
bottom part until it is firmly in place.
Replace the temperature control (only for the models with
interior controls), the shelves and the meat drawer.
Connect the refrigerator.
To change the light in the freezer, slide it sideways towards the
back of the freezer and then pull it towards you. To put it back
in place follow these instructions in the reverse order.
For models with the light on the top of the fresh food compartment,
remove the bulb cover from the far side, push towards you and take
out to the front and downwards. Replace the bulb. And follow
these instructions in the reverse order.
safety instructions
Do not touch the interior walls of the Freezer with wet hands.
Do not allow children to hag from the doors and/ or play near the
Refrigerator when the door is open as they could get injured or
trapped inside.
When you need to change the light bulb, disconnect the
refrigerator to avoid an electric discharge. Make sure that the light
bulb have the same characteristics, in size and power (watts)
5)
6)
7)
8)
9)
10)
11)
42
frequent questions
Before calling our Authorized Center, carry out an investigation
by consulting the following table. If after performing these tests
you are still in doubt, contact our service center and it will be our
pleasure to assist you.
To Next Page
Loading...
Need help?
General
