Need help?Do you have a question about the Mac Afric C0632C and is the answer not in the manual?
Details max swing diameter and distance between centers.
Covers spindle bore, taper, and speed ranges.
Lists threads, feed ranges, and pitches.
Remove crate, unbolt lathe, and prepare for lifting.
Choose a suitable location and ensure the lathe is level.
Clean anti-rust oil and grease the change gear assembly.
Proper sling technique for safe lifting and balancing.
Lists gears, screws, and nuts for headstock and feedbox.
Lists components for apron, tailstock, and change gear mechanisms.
Lists bearing types and specifications for the headstock.
Lists bearing types and specifications for the feed box.
Lists bearings for carriage and tailstock.
Procedures for lubricating the headstock and feed box.
Procedure for lubricating the apron.
Lubrication steps for leadscrew, tailstock, and carriage.
Lubrication points for cross slide and handwheel shafts.
Machine wiring, electrical box location, and grounding requirements.
Verifying proper spindle rotation direction for power connection.
Function of the waterproof seal for electrical apparatus protection.
Operation of control panel, speed, and feed selection levers.
Usage of traverse handwheels, feed selector, and carriage lock.
Operation of half nut, threading dial, and forward/reverse selector.
Clamping levers and handwheels for tool post and compound rest.
Clamping levers, handwheels, and adjustment for the tailstock.
Lists standard tools and equipment included with the machine.
Lists optional or specialized accessories available.
Details the initial 3-hour low-speed operation and 6-hour 800 RPM limit.
Advisable to check V-belt tension before starting operation.
Procedure for adjusting saddle gib screws for desired drag.
Procedure to tighten the cross slide gib screws.
Adjustment procedures for compound rest and tailstock.
Adjusting clearance of cross feed nuts on the saddle.
Describes the D-Cam Lock structure for mounting chucks/faceplates.
Details material and dimensions for the cross feed nut.
Details material and dimensions for the half nut.
To Next Page
General
