43
MCSWP2000S-2
In
more
detail...
EN
Troubleshooting
Troubleshooting
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and repair
work must be performed by an authorised service centre or
a similarly qualied specialist if you cannot solve the problem
yourself!
Suspected malfunctions are often due to causes that the users can
x themselves. Therefore check the product using this section. In
most cases the problem can be solved quickly.
Problem Possible cause Solution
1. Product does
not start.
1.1. Not connected to
power supply.
1.2. Power cord or plug
is defective.
1.3. Other electrical
defect to the
product.
1.1. Connect to power
supply.
1.2. Check by
a specialist
electrician.
1.3. Check by
a specialist
electrician.
2. Product does
not reach full
power.
2.1. Extension cord
not suitable for
operation with this
product.
2.2. Power source (e.g.
generator) has too
low voltage.
2.3. Air vents are
blocked.
2.1. Use a proper
extension cord.
2.2. Connect to another
power source.
2.3. Clean the air vents.
3. Unsatisfactory
result.
3.1. Saw chain is not
tensioned properly.
3.2. Saw chainis blunt.
3.1. Tension properly.
3.2. Sharpen or replace
saw chain.
To Next Page
Loading...
