29
In more detail...
MIS2400 by MacAllister
EN
Care and maintenance / Troubleshooting
4. Only transport the product by its transportation handle
(1). Tilt the product towards you until it balances on
the wheels (13). Then move it by its transportation
handle (1) (Fig. 14).
5. Protect the product from any heavy impact or strong
vibrations which may occur during transportation in
vehicles.
6. Secure the product to prevent it from slipping or
falling over, damage and injury.
1
13
Fig. 14
Troubleshooting
Suspected malfunctions are often due to causes that the users can x themselves.
Therefore check the product using this section. In most cases the problem can
be solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
by an authorised service centre or a similarly qualied specialist if you
cannot solve the problem yourself!
Problem Possible cause Solution
1. Product does
not start
1.1. Not connected to
power supply
1.2. Power cord or plug is
defective
1.3. Safety key inside
cover is not activated
1.4. Other electrical defect
to the product
1.1. Connect to power supply
1.2. Check by a specialist
electrician
1.3. Tighten the locking knob
(6) properly
1.4. Check by a specialist
electrician
2. Product does
not reach full
power
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source (e. g.
generator) has too low
voltage
2.3. Air vents (4) are
blocked
2.1. Use a proper extension
cord
2.2. Connect to another
power source
2.3. Clean the air vents
MNL_MIS2400_2400W Impact Shredder_GB_V2_220321.indd 29MNL_MIS2400_2400W Impact Shredder_GB_V2_220321.indd 29 2022/3/21 5:46 PM2022/3/21 5:46 PM
To Next Page
Loading...
