30
In more detail...
MIS2400 by MacAllister
EN
Troubleshooting / Recycling and disposal
Troubleshooting
3. Unsatisfac-
tory result /
shredding
material is not
cut cleanly
3.1. Cutting blade is dull /
damaged
3.2. Cutting material
exceeds capacity
3.1. Replace with a new one
3.2. Only cut materials
according to the product
capacity.
4. Product sud-
denly stops
4.1. Cutting blade is dull /
damaged
4.2. Cutting blade is
blocked
4.3. Overload protection
tripped
4.1. Replace with a new one
4.2. Remove blockage
4.3. Allow the motor to cool
down and reset the
overload protection, then
restart the unit
5. Excessive
vibration or
noise
5.1. Cutting blade is dull /
damaged
5.2. Cutting material
exceeds capacity
5.3. Bolts/nuts are loosen
5.4. Cutting blade is
blocked
5.1. Replace with a new one
5.2. Only cut materials
according to the product
capacity
5.3. Tighten bolts/nuts
5.4. Remove the blockage
Recycling and disposal
Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist.
Check with your Local Authority or local store for recycling advice.
For further information visit www.recycle-more.co.uk.
The product comes in a package that protects it against damage during shipping.
Keep the package until you are sure that all parts have been delivered and the
product is working properly. Recycle the package afterwards.
MNL_MIS2400_2400W Impact Shredder_GB_V2_220321.indd 30MNL_MIS2400_2400W Impact Shredder_GB_V2_220321.indd 30 2022/3/21 5:46 PM2022/3/21 5:46 PM
To Next Page
Loading...
