08
Safety information
Safety warnings
8. Have the product repaired only by an authorised
service centre or similar qualied specialist.
9. Never attempt to override the interlocked feature of
the cover.
10. Store the product in a dry place out of the reach of
children.
11. Always allow the product to cool before storing.
12. If the supply cord is damaged, it must be replaced by
the manufacture, its service agent or similarly qualied
in order to avoid the hazard.
Additional safety instructions for units with
bagging attachments
1. Switch the product off before attaching or removing
the collection bag.
Recommendations
1. The product should be supplied via a residual current
device (RCD) with a tripping current of not more than
30 mA.
2. Avoid using the product in bad weather conditions
especially when there is a risk of lightning.
3. Carry the product by the handle with the motor off.
Handling the product properly reduces the possibility
of personal injury.
4. If the product starts to vibrate abnormally, check it
immediately. Excessive vibration can cause injury.
5. Always ensure the product is fully assembled before
using it. Never attempt to use an incomplete product
or one tted with an unauthorised modication.
6. Do not overload the product.
7. Follow the maintenance and repair instructions for
this product. Never carry out any modications to the
product. Information about maintenance and repair is
MNL_MIS2400_2400W Impact Shredder_GB_V2_220321.indd 8MNL_MIS2400_2400W Impact Shredder_GB_V2_220321.indd 8 2022/3/21 5:46 PM2022/3/21 5:46 PM
To Next Page
Loading...
