28 29
MPWP2100-2 By MacAllister MPWP2100-2 By MacAllister
In more detail . . .
In more detail . . .
Intended use
This high pressure cleaner MPWP2100-2 is designated with a rated input of 2100 Watts.
The intended use of this product covers cleaning the surfaces of domestic vehicles,
buildings and patios using clean water and biodegradable chemical detergents.
1.
This product must not be used to clean clothing, shoes and other textiles. The water
jet should not be directed or held against anyone, any animals or electrical equipment
materials or liquids hazardous to health e.g. chemicals or asbestos. The product
2.
for the model in question is prohibited.
3. This product is intended for private domestic use only, not for any commercial trade
use. It must not be used for any purposes other than those described.
Safety devices
This product is equipped with several safety devices to avoid damage and injuries.
Overload cut-out
In case of overload, the motor stops. In this case, switch the product off, remove the
mains plug and let it cool down for 10 minutes, then repeat the startup.
1. Turn on the water tap fully.
2. Turn the On/Off switch
(3) to “I”.
3. Hold the spray gun
(16) with both hands.
4. Direct the nozzle of the chosen attachment away from yourself towards the surface
to be cleaned (Fig.
22).
5. Press the trigger
(16c) and direct the water jet to the object to be washed.
6. Release the trigger
(16d) to stop the water jet.
If the problem recurs more than once, contact your authorised service centre.
Fig. 22
Trigger lock
The spray gun (16) is equipped with a trigger lock in order to prevent accidental activation
of the trigger (16c).
1.
Activate the trigger lock by pressing the activate button (16d) when the product is
not in use, when it is left unattended or when setting the product down (Fig. 23).
2.
Deactivate the trigger lock by pressing the deactivate button (16d) to start operation
(Fig. 24).
16
16c
16d
Fig.
23
Fig. 24
16
16c
Fig.
23, trigger lock activated,
the trigger is locked in the
off position
Fig. 24, trigger lock deactivated,
the trigger can be operated
Safety valve
The safety valve is a pressure limiting valve. When the trigger (16c) is released, the
valve opens and discharges the pressure inside the pump.
Automatic motor start-stop device
Automatic motor start-stop device is operated by the trigger (16c) of the spray gun (16).
When the trigger (16c) is released the dynamic pressure automatically cuts out the motor.
When the trigger (16c) is depressed the automatic drop in pressure starts the motor and
the pressure is restored after a very slight delay.
If the automatic motor start-stop device is to function correctly all trigger releasing
and depressing operations must be performed with an interval of at least
5 seconds between each operation.
Product functionsProduct functions
GP65-3663602939702-EN-V06.indd 28-29 11/2/16 6:05 PM
To Next Page
Loading...
