30 31
MPWP2100-2 By MacAllister MPWP2100-2 By MacAllister
In more detail . . .
In more detail . . .
Operation
On/off switch
1. Make sure the on/off switch (3) is on “O”(off) (Fig. 25).
2. insert the plug
(1) into a properly installed socket.
3. Turn the on/off switch
(3) to “I” (on) (Fig. 26).
Fig. 25 Fig. 26
Note: The spray gun (16) is equipped with a trigger lock in order to prevent
accidental activation of the trigger (16c). Activate the trigger lock when the
product is not in use, when it is left unattended or when setting the product
down (Fig. 23).
4.
Deactivate the trigger lock by pressing
the deactivate button (16d) (Fig. 27).
5.
Press the trigger (16c), a water jet sprays
out of the nozzle.
6.
Release the trigger (16c) to stop the
water outlet.
Fig.
27
16
16c
16d
7.
Activate the trigger lock pressing the
activate button (16d) to lock the trigger
in its off-position (Fig. 28).
8. Turn the on/off switch
(3) to “O”.
Fig.
28
16
16c
16d
General operation
1.
Check the product, its power cord and plug as well as accessories for damage before
each use. Do not use the product if it is damaged or shows wear.
2.
3.
Always hold the product by the spray gun and lance. Keep the surfaces dry to ensure
safe support.
4.
Ensure that the air vents are always unobstructed and clear. Clean them if necessary
with a soft brush. Blocked air vents may lead to overheating and damage the product.
5.
Switch the product off immediately if you are disturbed while working by other people
entering the working area. Always let the product come to complete stop before
putting it down.
6.
Do not overwork yourself. Take regular breaks to ensure you can concentrate on
the work and have full control over the product.
Operation
WARNING! Do not operate the product when the ambient temperature is below
0 °C. Water will freeze inside the product and damage it.
WARNING! Do not operate the product with a closed water tap! This leads to
dry running and damage to the product! Rebound forces result from pressing
the trigger! Therefore, always hold the spray gun with both hands! Pay attention
to safe posture! Improper handling can lead to injuries!
1. Assemble the product as described.
2. Turn on the water tap fully.
3. Turn the On/Off switch
(3) to “I”.
4. Hold the spray gun
(16) with both hands.
5. Direct the nozzle of the chosen attachment away from
yourself towards the surface to be cleaned (Fig.
29).
6.
Press the trigger (16c) and direct the water jet to the
object to be washed.
Fig. 29
NOTE: Always keep a reasonable distance between the nozzle and the object
to be washed in order to avoid damage.
7. Release the trigger (16c) to stop the water jet.
Product functions
GP65-3663602939702-EN-V06.indd 30-31 11/2/16 6:05 PM
To Next Page
Loading...
