32 33
MPWP2100-2 By MacAllister MPWP2100-2 By MacAllister
In more detail . . .
In more detail . . .
Operation
Tips
WARNING! Prevent water from penetrating the air vents of the product to
minimize the risk of damage to the product and to reduce the risk of electric
shock to the operater!
1.
dry. Allow the detergent to soak into the surface for a few minutes, but do not let
the detergent dry.
2.
When dealing with vertical surfaces work from the bottom upwards. Leave the
detergent to act for 1-2 minute(s) but do not allow the surface to dry. Starting from
the bottom, use the high pressure jet at a minimum distance of
30 cm. Do not allow
the rinse water to run onto unwashed surfaces.
3.
In some cases, scrubbing the surface with a suitable brush is needed to remove
dirt. High pressure cleaning is not always the best solution for good washing results,
since it may damage some surfaces. The turbo jet spray nozzle vario nozzle jet
setting should not be used on delicate or painted parts, or on pressurised components
4. Effective washing depends on both the pressure and volume of the water used, to
the same degree.
5. Begin by spraying in a test area free and clear of people and objects.
Wood and vinyl decks
1.
Reduce your work area to smaller sections and clean each section one at a time
for optimal results.
2.
Rinse at high pressure using the fan spray keeping the tip of the spray nozzle at
least 15 - 25 cm from the cleaning surface.
3. Maintain a further distance from the cleaning area when using a direct spray.
4. Caution! Increase the distance from the cleaning area for softer woods.
Cement patios, stone, and brick
1. Rinse at high pressure using the fan spray in a sweeping motion keeping the tip of
the spray nozzle at least
7-15 cm from the cleaning surface.
2. Maintain a further distance from the cleaning area when using a direct spray.
Cars, boats, and motorcycles
1. Clean one side at a time to achieve the best results.
2. Rinse at high pressure using the fan spray in a sweeping motion keeping the tip of
the spray nozzle at least 20 cm from the cleaning surface. Maintain a further distance
from the cleaning area when using a direct spray.
3.
4. WARNING! Never clean the engine with this product!
Operation
After use
1. Release the trigger (16c) (Fig. 30)
Fig.
30
16c
2. Turn the on/off switch (3) to “O” (off).
3. Turn off the water tap.
4. Press the trigger
(16c) to release the pressure still present in the product (Fig. 31).
5. Lock the trigger
(16c) by pressing the activate button (16d) (Fig. 32).
16c
Fig. 31
Fig. 32
16
16c
16d
WARNING! Only separate the high-pressure hose from the spray gun and
the water hose from the product when no more pressure exists in the system!
Also ensure that the product is turned off and separated from electrical supply!
6. Disconnect from the power supply.
7. Separate the water hose from the water supply (Fig.
33).
Ø 13 mm
Fig.
33
GP65-3663602939702-EN-V06.indd 32-33 11/2/16 6:05 PM
To Next Page
Loading...
