84
Calibration
The Touch Screen Calibration adjustment is used to set the parameters of the touch screen to
ensure that when the screen is touched, it corresponds to the feature desired.
Note: Never use a pen or sharp object to calibrate the touch screen as this will damage the panel.
1. Touch the Calibrate Start icon and the rst screen will appear with instructions.
2. Follow the instructions on the screen touching and momentarily holding nger or a stylus to the
center of the target for 2 seconds. Repeat as the target moves to each corner of the screen
and nally to the center.
Calibration Screen
3. The second screen will appear:
Calibration Screen Conrmation
4. If the screen is touched, the new calibration parameters will be accepted. If the screen is not
touched within thirty seconds, the new parameters will be disregarded.
Illumination: Touch to access the Illumination screen. Touch a color to set the front panel display
to the selected color.
UI Color: Touch green, red, amber, blue or purple to select the user interface color. Touch again to
conrm and set the color.
Demo: Touch ON or OFF to turn the demonstration mode ON or OFF. The factory default setting is OFF.
Rear View Camera: Press “Mirror” to turn on the mirror function, press “Normal” to turn off.
To Next Page
Loading...
Need help?
General
