How to fix MAC TOOLS Jacks that won't lift the rated load?
If your MAC TOOLS jack isn't lifting its rated load, you should purge air from the hydraulic system. Follow the procedure outlined under the SETUP section to do this.
Why does my MAC TOOLS JSA350LR-LE Jacks feel spongy or not sustain rated load?
If your MAC TOOLS jack feels spongy or won't sustain the rated load, the suggested solution is to purge air from the hydraulic system. Refer to the SETUP section for the correct procedure.
What to do if my MAC TOOLS Jacks won't lift to full height?
If your MAC TOOLS jack isn't lifting to its full height, purge air from the hydraulic system. Consult the SETUP section for instructions on how to do this.
Why does the handle raise up on MAC TOOLS JSA350LR-LE Jacks under load?
If the handle of your MAC TOOLS jack tends to raise up while it's under a rated load, rapidly pump the handle several times. This action should push oil past the ball valves in the power unit and resolve the issue.
What to do if MAC TOOLS JSA350LR-LE will not lower completely?
If your MAC TOOLS jack isn't lowering completely, check the oil level. Ensure that the hydraulic system is not overfilled.
Essential directive to read and understand all operating instructions before use for safety.
Detailed steps for raising and lowering a vehicle using the jack and jack stands.
Monthly tasks for lubricating key components like pivot shafts, linkages, handles, and wheels.
Lists and diagrams parts for the hydraulic power unit assembly.
General| Model | JSA350LR-LE |
|---|---|
| Category | Jacks |
| Lifting Capacity | 3.5 tons |
| Material | Steel |
| Color | Red |
| Minimum Height | 3.75 inches |
| Maximum Height | 21.75 inches |
To Next Page