MAC TOOLS MW175 - Cleaning or Replacing GA16 C2 Gun Liner

OM-210 089 Page 23
5-5. Cleaning Or Replacing GA16C2 Gun Liner
Ref. ST-801 979
Tools Needed:
To Reassemble Gun:
Install contact tip.
Insert new liner.
Install collet onto liner and tighten
into gun/feeder connector using
wrench.
Cut liner off near collet so that liner
end is as close to drive rolls as
possible without touching.
Install nozzle.
Remove nozzle,
contact tip, and
liner collet.
Remove liner
Gun/feeder
connector
Blow out
gun casing.
3/8 in
3/8 in
3/8 in
Turn off welding power
source/wire feeder.