MAC3 PresSystem - Page 35

manual utilizare presostat electronic
pressystem
35
 Led Intermitent: presiunea minima
poate fi modificata cu butoanele + / -
a) Daca se apasa butonul EDIT, valoarea
va fi inregistrata permanent.
b) Daca se apasa butonul ON/OFF, se
iese din setare fara salvarea valorii.
 Led Off: no action
 Led Blinking: the pressure threshold
for the dry running restart can be
modified by using the + / - buttons.
a) If the EDIT button is pressed the
value will be stored permanently
b) If the ON/OFF button is pressed
the value will not be stored and it is
possible to exit without saving.
9
(vers.cosφ)
LED CURRENT:
 Led Activ: afiseaza amperajul fazei
masurat. Daca este apasat butonul
EDIT, este afisat amperajul setat
 Led Stins: nici o actiune
 Led Intermitent:
 Amperajul masurat depaseste
pragul setat
 Amperajul poate fi modificat cu
butoanele + / -
a) Daca se apasa vutonul EDIT,
valoarea va fi inregistrata
permanent.
b) Daca se apasa butonul ON/OFF, se
iese din setare fara salvarea valorii.
LED CURRENT:
 Led On: displays the measured
current. If the EDIT button is
pressed, the current value is
displayed.
 Led Off: no action
 Led Blinking:
 the measured current has
exceeded the current threshold.
 The current can be modified with +
/ - buttons.
a) If the EDIT button is pressed the
value will be stored permanently
b) If the ON/OFF button is pressed
the value will not be stored and it is
possible to exit without saving.
9
LED ERROR:
 Led Activ: Dispozitivul este blocat
pentru o eroare activa. Codul erorii
este afisat (codurile de eroare sunt
listate in sectiunea “Depanare si
Intretinere”)
LED ERROR:
 Led On: The device is blocked for an
alarm in progress. The error code is
displayed (error codes are listed in the
section "Troubleshooting and
Maintenance").
10
(vers.cosφ)
LED COSφ:
 Led Activ: afiseaza valoarea cosφ
masurata.
Daca apasati butonul EDIT, va fi
afisata valoarea cosφ setata.
 Led Stins: nici o actiune
 Led Intermitent: valoarea cosφ poate
fi mopdificata cu butoanele + / -
LED COSφ:
 Led On: displays the measured cosφ
value.
If the EDIT button is pressed, the cosφ
value is displayed.
 Led Off: no action
 Led Blinking: The cosφ value can be
modified with + / - buttons.