MAC3 PresSystem - Page 51

manual utilizare presostat electronic
pressystem
51
6. Scoateti clema senzorului de presiune (9)
(Figura 6).
7. Desurubati suruburile (10) si (11) ale placii
electronice (Figura 6).
8. Dupa scoaterea suruburilor este posibila
inlaturarea placii electronice (Figura 7).
Pentru montarea placii noi folositi
instructiunile in sens invers descrierii de
mai sus.
6. Unclip the connector of the pressure
sensor (9) (Figura 6).
7. Unscrew the screw (10) and (11) of the
electronic board (Figura 6).
8. After removing the screws is possible to
remove the electronic board for the
replacement (Figura 7) and follow in reverse
mode the assembly operations described
above for the new board.
Figura 6
Figura 7
9
11
10