26
MSCD18-Li-2
In more detail . . .
Product functions
Automatic work light (Fig. 12)
The work light (1) will automatically illuminate by pressing
the ON/OFF switch (6).
WARNING! Do not look directly into the light.
Two-speed gear control
The two-speed gear control (4) is used to switch between two working modes. When
the gear is set to position 1, the speed will decrease and the drill will have greater power
and torque. When the gear is set to position 2, the speed will increase and the drill will
have less power and torque (Fig. 13)
Gear
position
Description
1 Low speed range for screwdriving or working with large drilling
diameter
2 High speed range for working with small drilling diameter
Fig. 13
4
1
Fig. 12
To Next Page
Loading...